TABLE 292 Primary or secondary DHCP AP detects 90% of the configured total IPs event (continued)
Event
Event Code
Severity
Attribute
Displayed on the web
interface
Description
Both primary and secondary DHCP server APs are down
TABLE 293 Both primary and secondary DHCP server APs are down event
Event
Event Type
Event Code
Severity
Attribute
Displayed on the web
interface
Description
AP NAT gateway IP failover detected for particular VLAN pool
TABLE 294 AP NAT gateway IP failover detected for particular VLAN pool event
Event
Event Type
Event Code
Severity
Attribute
Displayed on the web
interface
Description
AP NAT gateway IP fall back detected for particular VLAN pool
TABLE 295 AP NAT gateway IP fall back detected for particular VLAN pool event
Event
Event Type
Ruckus SmartCell Gateway 200 Virtual SmartZone High Scale and SmartZone 300 Alarm and Event Reference Guide
Part Number: 800-71565-001 Rev A
Primary or secondary DHCP AP detects 90% of the configured total IPs
340
Warning
"zoneName"="ZoneName", "poolId"="xxxx","vlanId"="1", "allocatedIPNum"="5",
"totalIPNum"="10", "apMac"="xx:xx:xx:xx:xx:xx"
In zone [{zoneName}] DHCP IP pool [{poolId}] reached 90% threshold detected
by AP MAC [{apMac}]. VLAN ID: [{vlanId}] Allocated IPs: [{allocatedIPNum}], Total
IPs: [{totalIPNum}].
This event occurs when the primary or secondary DHCP AP reports that the IP
pool has reached 90% of the total number of allocated IP addresses.
Both primary and secondary DHCP server APs are down
apDHCPServiceFailure
341
Critical
"primaryServerMac"="xx:xx:xx:xx:xx:xx",
"secondaryServerMac"="xx:xx:xx:xx:xx:xx"
AP DHCP service failure . Both primary DHCP AP [{primaryServerMac}] and
secondary DHCP server AP [{secondaryServerMac}] are down.
This event occurs when the controller detects that the primary and secondary
DHCP APs have failed.
AP NAT gateway IP failover detected for particular VLAN pool
apNATFailoverDetected
342
Major
"natGatewayIP"="10.1.2.2", "vlanId"="2", "natGatewayMac"="xx:xx:xx:xx:xx:xx",
"apMac"="xx:xx:xx:xx:xx:xx"
NAT failover detected for [{natGatewayIP}], VLAN [{vlanId}], AP
[{natGatewayMac}]. Bringing up interface and switching traffic to AP [{apMac}].
This event occurs when any NAT gateway AP detects that a monitored NAT
gateway IP has failed.
AP NAT gateway IP fall back detected for particular VLAN pool
apNATFallbackDetected
Events Types
AP State Change Events
185
Need help?
Do you have a question about the Virtual SmartZone High Scale and is the answer not in the manual?
Questions and answers