Automatic Temperature Control (Atc); Climate Voice Recognition; Front Heated Seats; Power Front Seats Adjustment - Jeep WRANGLER 2024 Owner's Handbook Manual

Hide thumbs Also See for WRANGLER 2024:
Table of Contents

Advertisement

Mix Mode
Climate Control OFF Button
Press the button to turn the climate
control system off.
A
T
UTOMATIC
EMPERATURE
(ATC)
Automatic Operation
1.
Push the AUTO button on the faceplate or
the AUTO button on the touchscreen.
2.
Select the desired temperature using the
toggle switches or the touchscreen. The
system then achieves and automatically
maintains that comfort level.
NOTE:
There will be no need for you to move
the temperature settings for cold or hot vehicles.
The system automatically adjusts the
temperature, mode, and blower speed to provide
comfort as quickly as possible.
Manual Operation Override
Your Climate Control system includes manual
override features. The AUTO symbol in the front
ATC display will turn off when the system is in
the manual mode.
C
V
LIMATE
You can adjust your vehicle's temperature hands-
free while you're driving.
C
ONTROL
Push the VR button on the steering wheel. After
the beep, say one of the following commands:
"Set driver temperature to 70 degrees"
"Set passenger temperature to 70 degrees"
Did you know: Voice Recognition for Climate
may only be used to adjust the interior
temperature of your vehicle. Voice Recognition
will not work to adjust the heated seats or
steering wheel.
F
H
RONT
EATED
The heated seat control buttons are
located on the center instrument panel
below the touchscreen and also in
the Climate Control touchscreen menu.
Press the heated seat button to cycle through HI,
MED, LO, and off settings.
R
OICE
ECOGNITION
S
EATS
WARNING!
Persons who are unable to feel pain
to the skin because of advanced age,
chronic illness, diabetes, spinal cord injury,
medication, alcohol use, exhaustion or other
physical condition must exercise care when
using the seat heater. It may cause burns
even at low temperatures, especially if used
for long periods of time.
Do not place anything on the seat or
seatback that insulates against heat, such
as a blanket or cushion. This may cause
the seat heater to overheat. Sitting in a
seat that has been overheated could cause
serious burns due to the increased surface
temperature of the seat.
P
F
S
A
OWER
RONT
EATS
DJUSTMENT
The power seat switch and power seat recline
switch are located on the outboard side of the
seat near the floor. Use the power seat switch
to adjust seat height, angle, or forward/rearward
position. Use the power seat recline switch to
adjust the angle of the seatback.
Push the power lumbar switch forward to
increase the lumbar support. Push the switch
rearward to decrease the lumbar support.
Pushing upward or downward on the switch will
raise and lower the position of the support.
INTERIOR
27

Advertisement

Table of Contents
loading

Table of Contents