Disassembly And Assembly Adapter/Extension Housing And Front Bearing Retainer - Jeep Wrangler 1999 Electronic Service Manual

21 - 8 TRANSMISSION AND TRANSFER CASE
REMOVAL AND INSTALLATION (Continued)
Fig. 15 Install Adapter Housing Seal
(3) Install transfer case.
(4) Check and add fluid to transmission as neces-
sary. Refer to the Recommended Lubricant section for
proper fluid requirements.
(5) Lower vehicle.
DISASSEMBLY AND ASSEMBLY
ADAPTER/EXTENSION HOUSING AND FRONT
BEARING RETAINER
DISASSEMBLY
(1) Drain transmission lubricant, if necessary.
(2) Remove release bearing and lever.
(3) Remove clutch housing bolts and remove hous-
ing (Fig. 18).
(4) Remove vehicle speed sensor and speedometer
adapter, if necessary.
(5) Remove bolts holding shift tower to transmis-
sion case.
(6) Remove shift tower from transmission case
(Fig. 16).
(7) Remove shift tower gasket from shift tower or
transmission case (Fig. 17).
Fig. 16 Remove Shift Tower
Fig. 17 Remove Shift Tower Gasket
(8) Remove detent ball plug (Fig. 19).
(9) Remove detent spring and ball with pencil
magnet (Fig. 20), (Fig. 21).
(10) Remove shift arm retainer bolt (Fig. 22).
(11) Remove shift arm restrictor pins (Fig. 23).
(12) Remove shift lever shaft plug (Fig. 24).
(13) Remove shifter shaft with large magnet (Fig.
25).
(14) Remove the shift arm from the adapter hous-
ing.
TJ