Suzuki XL7 2007 Service Manual page 2011

15. Connect the seat belt pretensioner connector to the
adapter on the deployment harness.
NOTE
When deploying a seat belt retractor
pretensioner, the rapid expansion of gas is
very loud. Notify the people in the immediate
area that a seat belt pretensioner will be
deployed.
16. Clear the area of people.
17. Separate the 2 banana plugs on the SIR deployment
harness.
NOTE
When the seat belt retractor pretensioner
deploys, the deployment fixture may jump
about 30 cm (1 ft) vertically. This is a normal
reaction of the seat belt pretensioner due to
the force of the rapid expansion of gas inside
the pretensioner.
18. Place a 12 V minimum/2 A minimum power source,
such as a vehicle battery, near the shorted end of the
harness.
19. Connect the SIR deployment harness wires to the
power source. Seat belt pretensioner deployment
will occur when contact is made.
20. Disconnect the SIR deployment harness from the
power source after the seat belt retractor
pretensioner deploys.
21. Seat one banana plug into the other in order to short
the deployment harness leads.
22. If the seat belt retractor pretensioner did not deploy,
disconnect the adapter and discontinue the
procedure. Contact the Technical Assistance Group.
Otherwise, proceed to the following steps.
23. Put on a pair of shop gloves.
24. Disconnect the pigtail adapter from the seat belt
retractor pretensioner as soon as possible.
25. Dispose of the deployed seat belt retractor
pretensioner through normal refuse channels.
26. Wash hands with a mild soap.
Seat Belts: 8A-25