Suzuki XL7 2007 Service Manual page 1930

7A-116 Heating, Ventilation and Air Conditioning:
Installation Procedure
1. Add the proper of polyalkylene glycol (PAG) oil to the
evaporator core. Refer to "Refrigerant System
Capacities".
2. Inspect the seal around the evaporator core. Make
sure the seal is in correct position and retained
properly.
3. Install the evaporator core to the blower case
assembly.
4. Assemble the two halves of the blower case
assembly.
CAUTION
!
Refer to "Fastener Notice: ".
5. Install the blower case assembly screws.
Tightening torque
Tighten the screw to 1.5 N⋅m (13 lb in).
6. Install the HVAC module front of dash seal.
7. Install new seal washers to the evaporator pipes.
Refer to "Sealing Washer Replacement".
8. Instal the TXV and the backing plate to the
evaporator pipes.
9. Install the TXV screws to the backing plate.
Tightening torque
Tighten the screws to 3.5 N⋅m (31 lb in).
10. Install the evaporator case assembly. Refer to "Air
Conditioning (A/C) Evaporator Case Assembly
Replacement".
11. Install the HVAC module. Refer to "HVAC Module
Assembly Replacement".