Suzuki XL7 2007 Service Manual page 1928

7A-114 Heating, Ventilation and Air Conditioning:
13. Install the center I/P duct to the instrument panel tie
bar.
14. Install the center I/P duct retainers to the instrument
panel tie bar.
15. Install the center floor air outlet by sliding forward
onto the front floor air outlet then down and rearward
over the rear floor air outlet.
16. Install the shift control bracket. Refer to "Shift Control
Replacement: " for the AF33-5 transaxle.
17. Install the I/P retainer. Refer to "Instrument Panel
Retainer Replacement: ".
18. Install the heater inlet hose to the heater core.
19. Install the heater inlet hose clamp to the heater core.
20. Install the heater outlet hose to heater core outlet.
21. Install the heater outlet hose clamp to the heater
core.
22. Ensure the mating surfaces are clean and free of
debris, and install new seal washers to the
evaporator outlet hose and the liquid line. Refer to
"Sealing Washer Replacement".
23. Install the evaporator outlet hose and the liquid line
to the TXV.
24. Install the evaporator outlet hose and liquid line nut
to the TXV.
Tightening torque
Tighten the nut to 20 N⋅m (15 lb ft).
25. Enable the Supplemental Inflatable Restraints (SIR)
system. Refer to "SIR Disabling and Enabling: ".
26. Fill the coolant. Refer to "Draining and Filling Cooling
System (LY7 GE 47716 Fill): " "Draining and Filling
Cooling System (LY7 Static Fill): ".
27. Evacuate and charge the A/C system. Refer to
"Refrigerant Recovery and Recharging".
28. Test the affected A/C joints for leaks using J 39400-
A.