Suzuki XL7 2007 Service Manual page 1911

NOTE
Use a large pair of pliers to hold the fitting
while tightening the nut. Be careful not to
twist the line.
7. Install the liquid line nut to the condenser.
Tightening torque
Tighten the nut to 20 N⋅m (15 lb ft).
8. Install the bolt to retain the liquid line to the body.
Tightening torque
Tighten the nut to 9 N⋅m (80 lb in).
9. Remove the protective cap from the TXV, the liquid
line, and the evaporator outlet hose.
10. Install new seal washers to the liquid line and the
evaporator outlet hose. Refer to "Sealing Washer
Replacement".
Heating, Ventilation and Air Conditioning:
11. Install the liquid line and the evaporator outlet hose
to the TXV.
12. Install the liquid line and evaporator outlet hose
retainer plate nut to the TXV.
Tightening torque
Tighten the nut to 20 N⋅m (15 lb ft).
13. Install the four battery box bolts to the inside of the
battery box.
Tightening torque
Tighten the nut to 15 N⋅m (11 lb ft).
14. Install the battery box bolt to the outside of the
battery box.
Tightening torque
Tighten the nut to 10 N⋅m (89 lb in).
15. Install the battery. Refer to "Battery Replacement: ".
16. Install the liquid line to the strut tower.
17. Install the liquid line nut to the strut tower.
Tightening torque
Tighten the nut to 9 N⋅m (80 lb in).
7A-97