Table of Contents
Advertisement
Front Seat Belt Replacement (Quick
Connect)
Removal Procedure
1. Using a small flat-bladed tool, depress the button on
the seat buckle quick disconnect feature while
pulling up on the shoulder belt to disengage the
shoulder belt from the front seat assembly.
2. Remove the lower garnish molding from the center
pillar. Refer to "Center Pillar Lower Garnish Molding
Replacement: ".
3. Remove the retractor fastener and remove the
retractor.
4. Remove the shoulder belt webbing retainer by
pulling on the retainer while using a flat-bladed tool
to disengage the attaching clips.
5. Remove the shoulder belt from the vehicle.
Installation Procedure
NOTE
Apply GM P/N 12345382 (Canadian P/N
10953489), Permatex® 24200 or equivalent on
all restraint fasteners prior to installation.
1. Position the shoulder belt retractor into the center
pillar positioning unit with the locking tab in the body
structure notch.
CAUTION
!
Refer to "Fastener Notice: ".
2. Install the retractor fastener.
Tightening torque
Tighten the fastener to 45 N⋅m (33 lb ft).
3. Snap the shoulder belt webbing retainer into the
center pillar.
4. Install the lower garnish molding into the center
pillar. Refer to "Center Pillar Lower Garnish Molding
Replacement: ".
5. Install the seat belt to the seat assembly.
Seat Belts:
8A-15
Advertisement
Table of Contents
Troubleshooting
