Volkswagen Passat 1995 Official Factory Repair Manual page 1121

Multiport fuel injection and ignition system
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW...
- Check wiring between test box and
4-pin connector for open circuit
according to wiring diagram.
Terminal 1 and test box socket
33
Terminal 3 and test box socket
14
Resistance: maximum 1.5 ohms ( )
- Check wiring between test box and
4-pin connector terminal 3 for short
circuit to terminal 1 or to Ground
(GND), according to wiring diagram.
r Terminal 3 and test box socket 33
r Terminal 3 and vehicle Ground
(GND)
Specification:
- Additionally, check both wires for
short circuit to battery positive (B+).
Specification:
If no malfunction in wiring is detected:
- Perform resistance measurement at
ECT sensor -G62- terminals 1 and 3,
resistance values
Fig. 1 .
If the specification is not attained:
- Replace ECT sensor -G62-.
- Read readiness code
33 . If DTC memory has been
erased, repair must be verified via
appropriate display group
01-35 , Readiness code, creating.
Page 110 of 144
24-94
ohms ( )
ohms ( )
Page 24-18 ,
Page 01-
Page
6/12/2004