Configure The Master Alarm Name, Location, And Alarm Return Time - BeaconMedaes MedPlus TotalAlert Operation And Maintenance

Configure the Master Alarm Name, Location, and Alarm Return
Time
1. To configure the Master Alarm's location, zone, floor number, wing direction,
alarm return time, N2 address, facility description, and contact telephone
number, click on the Setup Device link. The Setup Device page displays (see
figure 1-35 on page 1–85).
Figure 1-35. Setup Device—Master Alarm
NOTE:
The information in these fields identify which Master Alarm that alarm or event
information is coming from. The identity displays on the monitor and in the
event log.
2. If you want to change the device name to a unique name, type the new name
in the Device Name window.
3. To access the Web pages by using the name you have given it, enable
NetBios Name Service over the TCP/IP in your Internet browser's settings
(see "Setting up the Internet Interface" on page 6-11).
a. This may require installing "Client for Microsoft® Networks" software.
b. Without the NetBios Name Service enabled, the device must be accessed
by using its IP address.
c. To learn the Master Alarm's IP address, press the Test key on its front
panel.
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)
Configuring and Browsing the Master Alarm Using the Web Pages
Chapter 1: Introduction
Page 1-85
1