Configure Master Alarm Inputs - BeaconMedaes MedPlus TotalAlert Operation And Maintenance

Configure Master Alarm Inputs

1. To configure the Master Alarm inputs, click on the Setup Alarm Messages
link. The Alarm Message Setup page displays (see figure 1-26 on page 1–77).
NOTE:
When configuring the Master Alarm using the Web pages, the configuration from
one Master Alarm can be transferred to another Master Alarm.
2. Before configuring the Master Alarm's inputs, refer to the Master Alarm
Input Signal Data table (see table 1-27 on page 1–56).
3. Click on the number link in the Alarm Input column for the input that you
want to configure. The Alarm Step 2 page displays (see figure 1-27 on page
1–78).
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)
Configuring and Browsing the Master Alarm Using the Web Pages
Figure 1-26. Alarm Message Setup
Chapter 1: Introduction
Page 1-77
1