Replacement - BeaconMedaes MedPlus TotalAlert Operation And Maintenance

5. Using a screwdriver, loosen the screws in the transducers wiring connector
(I).
6. Remove the transducer wiring.
7. Using needle nose pliers, pull the flag terminals (F) off of the Breakout P.C.
Board (C) connectors (G).
NOTE:
There may be auxiliary wiring to the building automation system that needs to be
disconnected.
8. Pull the Breakout P.C. Board (C) off of the mounting pegs (D).

Replacement

1. To replace the Breakout P.C. Board, reverse the order of the removal instruc-
tions.
2. To ensure proper operation, perform the "Function Checks" on page 2–5.
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)
Chapter 4: Removal, Replacement, and Adjustment Procedures
Area Alarm Breakout P.C. Board
Page 4-23
4