Power Supply Fuse Holder; Removal - BeaconMedaes MedPlus TotalAlert Operation And Maintenance

Power Supply Fuse Holder

Chapter 4: Removal, Replacement, and Adjustment Procedures

4.16 Power Supply Fuse Holder

Tools required:

Removal

Turn off the source power to the alarm, and leave it off during the installa-
tion of any component or sub-assembly. Failure to do so could result in
personal injury or equipment damage.
1. Turn off power to the alarm at the facility's source.
2. Depending on which alarm you are replacing the fuse on, take one of the fol-
lowing steps:
•
•
Page 4-42
Needle nose pliers
5/32" hex wrench
or
Phillips head screwdriver
Shock Hazard:
Unless the replacement is being performed on a Local Alarm, use a
5/32" hex wrench to unlock the front panel (A) (see figure 4-17 on page
4–43).
When changing the power supply fuse holder in the Local Alarm, use a
phillips head screwdriver to remove the front panel.
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)