Returning To Normal Operating Mode - BeaconMedaes MedPlus TotalAlert Operation And Maintenance

Returning to Normal Operating Mode

To return to normal operating mode and save any changes that you have made at
any time, do one of the following:
• Press the configuration button (CD) (see figure 1-20 on page 1–64).
• Turn the power supply switch (DQ) to the OFF position and then back
to the ON position (see figure 1-19 on page 1–63).
If you do not press any keys for 10 minutes, the alarm returns to normal opera-
tion and saves any changes that you have made.
While in the configuration mode, the front panel keys operate differently than
they do in normal operation mode (see figure 1-21 on page 1–65 and table 1-29
on page 1-66).
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)
Configuring the Master Alarm Using the Front Panel
Figure 1-21. Master Alarm Front Panel
Chapter 1: Introduction
Page 1-65
1