Setting Up The Internet Interface - BeaconMedaes MedPlus TotalAlert Operation And Maintenance

6.2

Setting up the Internet Interface

CAUTION:
Have the facility's Information Systems personnel set up the Internet inter-
face. If the set up is done improperly, equipment may not perform proper-
ly.
When the Internet interface is ready to be set up, have the facility's Information
Systems personnel set it up.
CAUTION:
The Information Systems personnel should be notified before changing
any of the network settings. Changing the settings could keep the equip-
ment from working properly.
If changes to the Internet interface setup are needed, have the facility's
Information Systems personnel make the necessary changes.
The Master Alarm Module and Area Alarm Network Communications Board
arrive ready for Ethernet communication on most networks by using either an
RS-232 serial connector (BP) or an RG-45 connector (BO) (see figure 6-5 on
page 6–12). The devices communicate by using TCP/IP on most office networks.
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)

Setting up the Internet Interface

Chapter 6: General Procedures
Page 6-11
6