Cleaning; Steam Cleaning; Cleaning Hard To Clean Spots; Disinfecting - BeaconMedaes MedPlus TotalAlert Operation And Maintenance

Cleaning

Chapter 6: General Procedures

Cleaning

Follow the product manufacturer's instructions. Failure to do so could
result in personal injury or equipment damage.
Do not expose the unit to excessive moisture that would allow for liquid
pooling. Personal injury or equipment damage could occur.
Do not use harsh cleansers/disinfectants such as scouring pads, heavy
duty grease removers, solvents such as toluene, xylene, or acetone.
Equipment damage could occur.
BeaconMedæs recommends using a damp cloth to clean the MedPlus
TotalAlert® Alarm Network front panels.

Steam Cleaning

Do not use any steam cleaning device on the unit. Excessive moisture can dam-
age mechanisms in this unit.

Cleaning Hard to Clean Spots

To remove difficult spots or stains, we recommend that you use standard house-
hold cleansers and a soft-bristled brush. To loosen heavy, dried-on soil, you may
first need to saturate the spot.

Disinfecting

When there is visible soilage and between patients, we recommend that you dis-
infect the unit with a tuberculocidal disinfectant. (For customers in the US, the
disinfectant should be registered with the Environmental Protection Agency.)
NOTE:
The MedPlus TotalAlert® Alarm Network is not intended for patient contact and
ordinarily should not require disinfection.
Page 6-28
WARNING:
Shock Hazard:
CAUTION:
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)