Model Identification - BeaconMedaes MedPlus TotalAlert Operation And Maintenance

Model Identification

There are several different configurations of the MedPlus TotalAlert® Alarm
Network (6819), and the product numbers for each configuration are determined
by the following factors (see table 1-20 on page 1–49):
a. Revision level—All revisions are "A" at this time.
b. Alarm type.
c. Communication (Comms) option—This is the Ethernet-ready option, and
it only applies to Area Alarms (see table 1-21 on page 1–51).
d. Transducer mounting type—This only applies to the three-module area
alarm conversion kit (6819-A10) and the six-module area alarm conver-
sion kit (6819-A11) (see table 1-22 on page 1–51).
NOTE:
The transducers for the conversion kit model number 6819-A12 always mount
inside the rough-in box, so no transducer mounting type code is needed.
e. Gas types (see table 1-23 on page 1–52).
f. Country of destination (see table 1-24 on page 1–52).
Cover plates are available to cover unused rough-in boxes (see table 1-25 on
page 1–52).
Table 1-20. MedPlus TotalAlert® Alarm Network Product Number Layouts
Comms
Base
code
6819-A4 #
Comms
Base
code
6819-A3 #
Comms
Base
code
6819-A11 #
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)
6 Module Area Alarm
Gas Gas Gas
code 1 code 2 code 3
# # #
3 Module Area Alarm
Gas Gas Gas
code 1 code 2 code 3
# # #
6 Module Area Alarm Conversion Kit
Trans-
Gas Gas
ducer
code 1 code 2
code
# # #
Gas Gas Gas
code 4 code 5 code 6
# # #
Country
code
##
Gas Gas Gas
code 3 code 4 code 5
# # #

Model Identification

Chapter 1: Introduction
Country
code
##
Gas Country
code 6 code
# ##
Page 1-49
1