Master Alarm Rough-In Assembly - BeaconMedaes MedPlus TotalAlert Operation And Maintenance

Master Alarm Rough-In Assembly

The Master Alarm Rough-In Assembly consists of the Breakout P.C. Board (A),
back box (E), mounting brackets (BM), and power supply (see figure 1-4 on page
1–13). The power supply includes the following:
• Ground terminal (B)
• Terminal block (C)
• Power supply covers (F, G)
• On/Off switch (H)
• Fuse holder (I)
• Transformer (D)
NOTE:
The mounting brackets are not attached when they are shipped. Attach them
before installation. For more information about installing an original alarm net-
work, refer to the MedPlus TotalAlert® Alarm Network Installation Instructions.
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)
Figure 1-4. Master Alarm Rough-In
Features
Chapter 1: Introduction
Page 1-13
1