Area Alarm Front Panel - BeaconMedaes MedPlus TotalAlert Operation And Maintenance

Features
Chapter 1: Introduction
When installing the MedPlus TotalAlert® Alarm Network Conversion Kit, the
Breakout P.C. Board and the power supply assembly mount in the existing
alarm's rough-in box. The conversion kit power supply mounts as single sub-
assembly, but uses the same internal components as the original power supply.
For more information about installing a conversion kit, refer to the MedPlus
TotalAlert® Alarm Network Conversion Kits Installation Instructions.

Area Alarm Front Panel

The Area Alarm Front Panel is designed to swing open from the rough-in assem-
bly (R) to easily install and service the alarm. The panel consists of the following
(see figure 1-8 on page 1-18):
• Faceplate (AA)
• Hinged door (Z)
• P.C. board, either an Area Alarm Network Communications Board (W) or an
Area Alarm Connector P.C. Board (not shown)
• Area Alarm Modules (Y)
• Lock (X)
Page 1-18
Figure 1-8. Area Alarm Front Panel
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)