Master Alarm Breakout P.c. Board; Removal - BeaconMedaes MedPlus TotalAlert Operation And Maintenance

Master Alarm Breakout P.C. Board

Chapter 4: Removal, Replacement, and Adjustment Procedures
4.4

Master Alarm Breakout P.C. Board

Tools required:

Removal

1. Using a 5/32" hex wrench, unlock the front panel (A) (see figure 4-5 on page
4–14).
Turn off the power supply in the alarm, and leave it off during the installa-
tion or replacement of any component or sub-assembly. Failure to do so
could result in personal injury or equipment damage.
2. Turn the power switch (G) to the OFF position.
3. Note the positions of the wiring at the connectors (I) for the source equip-
ment.
4. Using a screwdriver, loosen the screws in the connectors (I).
Page 4-14
5/32" hex wrench
Needle nose pliers
Screwdriver
Figure 4-5. Master Alarm Breakout P.C. Board
Shock Hazard:
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)