Area Alarm Connector P.c. Board Or Network Communications Board; Removal - BeaconMedaes MedPlus TotalAlert Operation And Maintenance

Area Alarm Connector P.C. Board or Network Communications Board

Chapter 4: Removal, Replacement, and Adjustment Procedures
4.8 Area Alarm Connector P.C. Board or Network
Communications Board
Tools required:

Removal

1. Using a 5/32" hex wrench, unlock the front panel (A) (see figure 4-9 on page
4–24).
Figure 4-9. Area Alarm Connector P.C. Board or Network Communications Board
Turn off the power supply in the alarm, and leave it off during the installa-
tion or replacement of any component or sub-assembly. Failure to do so
could result in personal injury or equipment damage.
2. Turn the power switch (H) to the OFF position.
The Area Alarm has either a Connector P.C. Board (D) or a Network
Communications Board (E) mounted to the back of the front panel (A).
Page 4-24
5/32" hex wrench
Shock Hazard:
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)