Local Alarm P.C. Board
Chapter 4: Removal, Replacement, and Adjustment Procedures
4.12 Local Alarm P.C. Board
Tools required:
Removal
1. Using a phillips head screwdriver, loosen the screws (A) enough to allow the
front panel (B) to slide off (see figure 4-13 on page 4–34).
2. Slide the front panel (B) up and off of the back box (G).
Turn off the power supply in the alarm, and leave it off during the installa-
tion or replacement of any component or sub-assembly. Failure to do so
could result in personal injury or equipment damage.
3. Turn the power switch (H) to the OFF position.
4. Unplug the buzzer wiring (E).
Page 4-34
Phillips head screwdriver
5/16" nut driver
Figure 4-13. Local Alarm P.C. Board
Shock Hazard:
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)