Rear Door Panel - Subaru IMPREZA 2001 Service Manual

EXTERIOR BODY PANELS

6. Rear Door Panel

A: REMOVAL
CAUTION:
• During removal and installation of doors, do
not damage body.
• Doors are heavy. Be careful not to drop and
damage them.
1) Disconnect ground cable from battery.
2) Remove rear door trim. <Ref. to EI-21, REMOV-
AL, Rear Door Trim.>
3) Remove rear door regulator and motor assem-
bly. <Ref. to GW-34, REMOVAL, Rear Regulator
and Motor Assembly.>
4) Remove rear door latch. <Ref. to SL-34, RE-
MOVAL, Rear Door Latch Assembly.>
5) Remove rear outer handle. <Ref. to SL-33, RE-
MOVAL, Rear Outer Handle.>
6) Remove center pillar lower trim. <Ref. to EI-29,
REMOVAL, Lower Inner Trim.>
7) Disconnect connector of door harness.
8) Put a wooden block on the jack and place the
jack under the door. Support the door with the jack
to protect it.
REAR DOOR PANEL
9) Remove checker bolts.
10) Remove door-side bolts for upper and lower
hinges to remove door.
11) Using special tool, remove body-side bolts for
upper and lower hinges, and remove door hinges.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Apply grease to sliding area of door hinges.
BO0154
BO0261
EB-14
S5M0183
G5M0385