Rear Brake Shoe Inspection; Wheel Cylinder Removal And Installation - Suzuki 2006 SX4 Service Manual

3) Remove return springs, brake shoes and adjuster.
4) Disconnect parking brake shoe lever (1) from
parking brake cable (2).
5) Remove push nut (1).
6) Remove parking brake shoe lever (2) from shoe rim
(3).
Installation
Install parts in reverse order of removal, noting the
following.
• Before installing rear brake shoe to brake back plate,
clean brake back plate and apply heat-resistance
brake grease to A on which shoe rims rest.
A
• Push and rotate 90° hold down pin and install hold
down pin and hold down spring.
• Install brake drum referring to "Rear Brake Drum
Removal and Installation".

Rear Brake Shoe Inspection

• Check ratchet of brake adjuster (1) assembly for wear
• Check shoe return spring, antirattle spring, quadrant
• Check for smooth movement of brake shoe lever (2)
If any defective or malfunction is found, repair or replace.
I2RH01430013-01
1
3

Wheel Cylinder Removal and Installation

2
Removal
1) Remove brake drum referring to "Rear Brake Drum
2) Remove brake shoe referring to "Rear Brake Shoe
I4RS0A430014-01
3) Loosen brake pipe flare nut (1) but only within the
4) Remove wheel cylinder mounting bolt (3).
A
I6JB0A430002-01
or damage.
spring and shoe hold down spring for damage,
corrosion and weakening.
along shoe rim.
Removal and Installation".
Removal and Installation".
extent that fluid does not leak.
Disconnect brake pipe from wheel cylinder and put
bleeder plug cap (2) onto pipe to prevent fluid from
spilling.
3
2
Rear Brakes: 4C-4
S6RW0D4306006
I4RS0A430016-01
S6RW0D4306007
1
I7RW01431004-01