LAPIS Semiconductor ML62Q1000 Series User Manual page 579

Bit Bit symbol
name
No.
0 Pn2IE
[Note]
Ÿ
Be sure to set the PnMODm(n＝0 to B, m=0 to 7) registers before setting EICON0, EIMOD0 and IE1
registers. If setting the PnMODm register when the interrupt is enabled, unexpected interrupts may
happen.
Ÿ
Enable the output by setting the PnmOE bit after the following configutation.
In the case of general ports: Determine the output data in the PnmDO bit of PnD register
In the case of shared functions: Configure the peripheral mode settings in the PnmMD3 to PnmMD0 bit.
FEUL62Q1000
This bit is used to enable the input of Pn2 pin
0: Disable the input (initial value)
1: Enable the input
ML62Q1000 Series User's Manual
Chapter 17 General Purpose Port
Description
17-20