LAPIS Semiconductor ML62Q1000 Series User Manual page 22

l Simplified RTC (ML62Q1500 and ML62Q1700 group)
−
Channel: 1 ch
−
Count by one second from "00 min. 00 sec" to "59 min. 59 sec"
−
One interrupt occurrence is selectable from four periodical interrupt requests (0.5sec, 1sec, 30sec or 60sec)
−
Protect function for incorrect writing the minutes and second.
l
Functional timer (FTM)
−
Channel: Max. 8ch
−
Repeat mode, One shot mode, Caputure mode, PWM mode1 and PWM mode 2(complementary output)
−
Same start/stop is avaible with different channels
−
(This function is not avaible with 16bit Genral Timer)
−
Event trigger (external interrupts, analog comprator interrupts, 16bit genral timer interrupts and 16bit functional
timer interrupts)
−
Dead time is generatable
−
Available to specify devision ratio of counter clock channel by channel
l
16bit General timers
−
Channel: Max. 8ch
−
8 bits timer mode and 16-bit timer mode (1ch 16-bit timer is configurable as 2ch 8-bit timer)
−
Same start/stop is avaible with different channels
−
(This function is not avaible with 16bit Functional Timer)
−
Timer output (toggled by overflow)
−
Available to specify devision ratio of counter clock channel by channel
l
Serial communication unit
−
Synchronous Serial Port or UART is seletable in each channel
−
Channel: Max. 6ch
< Synchronous Serial Port >
‒ Master/slave selectable
‒ LSB first/MSB first selectable
‒ 8-bit length/16-bit length selectable
< UART >
‒ Full-duplex communication x 2 ch (One Full-duplexUART is configurable as two half-duplex UARTs)
‒ 5 to 8 bit length, parity/no parity, odd parity/even parity, 1 stop bit/2 stop bits
‒ Positive logic/negative logic selectable
‒ LSB first/MSB first selectable
‒ Wide range of communication speed
32.768kHz operation clock : 1bps to 4,800bps
24MHz operation clock : 600bps to 3Mbps
16MHz operation clock : 300bps to 2Mbps
‒ Internal baud rate generator
FEUL62Q1000
ML62Q1000 Group User's Manual
Chapter 1 Overview
1-5