Waveform Commands - Teledyne T3DSO1000 Programming Manual

Digital Oscilloscope Series

WAVEFORM Commands

The WAVEFORM subsystem is used to transfer data to a controller from the
oscilloscope waveform memory.
The waveform record is actually contained in two portions: the preamble and
waveform data. The waveform record must be read from the oscilloscope by the
controller using two separate commands. The waveform data is the actual data
acquired for each point in the specified source. The preamble contains the
information for interpreting the waveform data.
� WF?
� WFSU
178