Teledyne T3DSO1000 Programming Manual page 43

CHANNEL
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
RESPONSE FORMAT
EXAMPLE
Digital Oscilloscope Series
The COUPLING command selects the coupling
mode of the specified input channel.
The COUPLING? query returns the coupling
mode of the specified channel.
<channel>:COUPLING <coupling>
<channel>:={C1,C2,C3,C4}
<coupling>:={A1M,A50,D1M,D50,GND}
• A — alternating current.
• D — direct current.
• 1M — 1MΩ input impedance.
• 50 — 50Ω input impedance.
Note:
Options of <coupling> vary from models. See
the data sheet or the channel menu of
oscilloscope for details.
<channel>:COUPLING?
<channel>:COUPLING <coupling>
The following command sets the coupling of
Channel 2 to 50 Ω, DC.
Command message:
C2:CPL D50
COUPLING | CPL
Command /Query
43