Sending Commands To Activate The Outputs - Teledyne 804A User Manual

804 Series Video Test Generator – User Guide
5. Establish a connection using a terminal program such as Hyperterm or an Automated Test System (ATS). You will need
to know the port number for the USB connector. This can be found in the Device Manager in a Windows OS.
6. Press the More button to access the RS-232 Baud Rate setting as follows:

Bits per second: 115200 or 9600

Data bits: 8

Parity: None

Stop bits: 1

Flow control: None
Note: You do not need to set the baud rate if you are using the USB connection.
When you send a command you will see the Tx and Rx lights on the 804/804A/804B front panel flash briefly.
6.2

Sending commands to activate the outputs

The following examples depict some commonly used commands for controlling the 804/804A/804B outputs.
1. Activate the HDMI interfaces:
XVSI 4
ALLU
2. Load and activate a format.
FMTL 720p60
Page 21 Revision B3