Teledyne T3DSO1000 Programming Manual page 162

TRIGGER
DESCRIPTION
COMMAND SYNTAX
EXAMPLE
RELATED COMMANDS
Digital Oscilloscope Series
The SET50 command automatically sets the
trigger levels to center of the trigger source
waveform.
When High and Low (dual) trigger levels
are used (as Runt triggers, for example), this
command has no effect.
SET50
When the trigger type is edge and the
trigger source is Channel 1, the following
command sets the trigger level to the center
of Channel 1.
Command message:
SET50
TRLV
SET50
Command
162