Teledyne T3DSO1000 Programming Manual page 63

DIGITAL
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
RESPONSE FORMAT
EXAMPLE
Note:
The table below shows the availability of command in each oscilloscope series.
Model
T3DSO2000
T3DSO1000
Digital Oscilloscope Series
The SWITCH command is used to set the state
of digital.
The SWITCH? query returns the state of digital.
<function>:SWITCH <state>
<function>:={DI}
<state>:={OFF,ON}
<function>:SWITCH?
<function>:SWITCH <state>
For T3DSO1000 series, the following command
sets Digital function on.
Command message:
DI:SWITCH ON
Valid?
no
yes
SWITCH | SW
Command /Query
63