Teledyne T3DSO1000 Programming Manual page 117

PASS/FAIL
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
RESPONSE FORMAT
EXAMPLE
Note:
The table below shows the availability of command in each oscilloscope series.
Model
T3DSO2000
T3DSO1000
Digital Oscilloscope Series
PF_FAIL_STOP | PFFS
The PF_FAIL_STOP command sets the switch
of the "stop on fail" function. This is the same as
pressing the "Stop on Fail" button on the menu
of PASS/FAIL on the front panel.
The PF_FAIL_STOP? query returns the state of
the "stop on fail" function.
PF_FAIL_STOP <state>
<state>:={ON,OFF}
• ON — To monitor the failure waveform, the
oscilloscope stops testing and enters the "STOP"
state. At this point, the screen displays the last
statistical result.(if the display is already open)
• OFF — To monitor the failure waveform, the
oscilloscope will continue to test and update the
statistics on the screen immediately.
PF_FAIL_STOP?
PF_FAIL_STOP <state>
The following command sets "stop on fail" to
"off".
Command message:
PFFS OFF
Valid?
no
yes
Command/Query
117