Teledyne T3DSO1000 Programming Manual page 51

CURSOR
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
RESPONSE FORMAT
EXAMPLE
RELATED COMMANDS
Digital Oscilloscope Series
CURSOR_MEASURE | CRMS
The CURSOR_MEASURE command specifies
the type of cursor or parameter measurement to
be displayed
The CURSOR_MEASURE? query returns
which cursors or parameter measurements are
currently displayed.
CURSOR_MEASURE <mode>
Format 1:
<mode>:={OFF,ON}
• OFF — manual mode.
• ON — track mode.
Format 2:
<mode>:={OFF,MANUAL,TRACK}
• OFF — close the cursors.
• MANUAL — manual mode.
• TRACK — track mode.
Note:
The table on next page shows the available
command format in each oscilloscope series.
CURSOR_MEASURE?
CURSOR_MEASURE <mode>
• The following command turns cursor function
off on the T3DSO1000.
Command message:
CRMS OFF
• The following command sets cursor mode to
track mode on the T3DSO1000.
Command message:
CRMS ON
CRVA?
CRST
Command /Query
51