Teledyne T3DSO1000 Programming Manual page 113

PASS/FAIL
DESCRIPTION
COMMAND SYNTAX
EXAMPLE
RELATED COMMANDS
Digital Oscilloscope Series
PF_CREATEM | PFCM
The PF_CREATEM command creates a pass/ fail
test rule around the current selected channel, using
the horizontal adjustment parameters and the
vertical adjustment parameters defined by the
PFST commands.
Note:
This command is valid only if the pass / fail test
function has been opened (PFEN) and is not in
operation (PFOP).
PF_ CREATEM
The following steps create the mask of the pass/fail.
Step 1: Send command to set the Pass/Fail test
enable.
Command message:
PFEN ON
Step 2: Send command to stop the operation.
Command message:
PFOP OFF
Step 3: Send command to create the rule.
Command message:
PFCM
PFST
PFSC
PFEN
PFOP
Command
113