Teledyne T3DSO1000 Programming Manual page 216

In this example, the VI opens a VISA session to a USBTMC device, writes
a command to the device, and reads back the response. After all
communication is complete, the VI closes the VISA session.
6. Communicating with the device via TCP/IP is similar to USBTMC. But
you need to change VISA Write and VISA Read Function to Synchronous
I/O. The LabVIEW default is asynchronous I/O. Right-click the node and
select Synchronous I/O Mod>>Synchronous from the shortcut menu to write
or read data synchronously.
7. The connection is as shown in the figure below:
8. Input the IP address and run the program.
T3DSO1204,0123456789, 7.6.1.15
Digital Oscilloscope Series
216