Teledyne T3DSO1000 Programming Manual page 48

CHANNEL
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
RESPONSE FORMAT
EXAMPLE
RELATED COMMANDS
Digital Oscilloscope Series
The VOLT_DIV command sets the vertical
sensitivity in Volts/div.
If the probe attenuation is changed, the scale
value is multiplied by the probe's attenuation
factor.
The VOLT_DIV? query returns the vertical
sensitivity of the specified channel.
<channel>:VOLT_DIV <v_gain>
<channel>:={C1,C2,C3,C4}
<v_gain>:= 500uV to 10V.
Note:
If there is no unit (V/mV/uV) added, it
defaults to volts (V).
<channel>:VOLT_DIV?
<channel>:VOLT_DIV <v_gain>
<v_gain>:= Numerical value in E-notation with
SI unit.
The following command sets the vertical
sensitivity of Channel 1 to 50 mV/div.
Command message:
C1:VDIV 50mV
ATTN
VOLT_DIV | VDIV
Command /Query
48