Teledyne T3DSO1000 Programming Manual page 147

INternal State Register (INR) Structure
Bit Bit
value
15 ---
14 ---
13 8192
12 4096
11 2048
10 1024
9 512
8 256
7 128
6 64
5 ---
4 16
3 8
2 4
1 2
0 1
Step 5: After sending the query in step 4, send the
query again.
Response message:
INR 0
Step 6: After step 2, not to input the signal, change
the trigger mode to single. And then, send the query.
Response message:
INR 8192
Description
Not used (always 0)
Not used (always 0)
Trigger is ready
Pass/Fail test detected desired outcome
Waveform processing has terminated in Trace D
Waveform processing has terminated in Trace C
Waveform processing has terminated in Trace B
Waveform processing has terminated in Trace A
A memory card, floppy or hard disk exchange has been detected
Memory card, floppy or hard disk has become full in ― AutoStore
Fill‖ mode
Not use(always 0)
A segment of a sequence waveform has been acquired
A time-out has occurred in a data block transfer
A return to the local state is detected
A screen dump has terminated
A new signal has been acquired
Digital Oscilloscope Series
147