Table of Contents
Advertisement
Digital Oscilloscope Series
Introduction to the SCPI Language
About Commands & Queries
This section lists and describes the remote control commands and queries
recognized by the instrument. All commands and queries can be executed
in either local or remote state.
The description for each command or query, with syntax and other
information, begins on a new page. The name (header) is given in both
long and short form at the top of the page, and the subject is indicated as
a command or query or both.
The commands are given in long format for the "COMMAND SYNTAX"
and "QUERY SYNTAX" sections and they are used in a short form for the
"EXAMPLE" .
Queries perform actions such as obtaining information, and are recognized
by the question mark (?) following the header.
Description
In the description, a brief explanation of the function performed is given.
This is followed by a presentation of the formal syntax, with the header
given in upper case characters and the short form derived from it. Where
applicable, the syntax of the query is given with the format of its response.
Usage
The commands and queries listed here can be used for the T3DSO1000
and T3DSO2000 Digital Oscilloscope Series.
14
Hide quick links:
Advertisement
Table of Contents
