Suspension Arm - Honda Fourtrax Rancher AT 2004 Service Manual

FRONT WHEEl/SUSPENSION/STEERING
Insert the lower mounting bolt from the front side.
Install new mounting nut.
Remove the support and place the vehicle on level
ground.
Tighten the upper and lower mounting nuts to the
specified torque.
TORQUE: 30 N·m f3.1 kgf·m, 22Ibf.ft)
SUSPENSION ARM
REMOVAL
Remove the front wheel (page 14-12).
Remove the cotter pi ns and loosen the castle nuts.
but do not remove them yet.
Release the ball joints. using the special tool accord·
ing to the instructions described on page 14-17.
TOOL:
8a1l joint remover 07MAC·SLOO200
Do
not hang the
Remove the castle nuts on the ball joints and sup-
bra;'B drum/knuckle
port the brake drum/knuckle assembly.
assembly from the
brake hose.
Do
nol
rwlSllhe brake
00"
M'LL .IUII"
REMOVER
14-23