Honda Fourtrax Rancher AT 2004 Service Manual page 136

FUEL SYSTEM
Connect the starting enrichment (SE) valve to the SE
valve cable.
Install the SE valve into the carbu retor.
Tighten the SE valve nut to the specified torque.
TORQUE: 2 N·m (0.2 kgf-m . 1.4 Ibf -ft )
Route the throttle position sensor wire and clamp it
~~~~~~~~~~~~~~~~~~~~
with a clamp on the diaphragm cover. 3P (BLACK) CONNECTOR
6-22
Connect the TP sensor 3P (Black) connector.
Connect the fuel hose to the carburetor.
Connect the air vent hose to the carburetor.
Install the air cleaner housing (page 6-5).
Perform the following inspections and adjustments:
- engine idle speed (page 4- 14)
- t hrottle operation (page 4-5)
- pilot screw if it was replaced (page 6-23)
Perform the initial setting (page 24-9) after all carbu-
retor adjustments have been completed.
AIR VENT HOSE
\\ \ '\ FUEL HOSE
WIRE CLAMP