Mode Select Switch - Honda Fourtrax Rancher AT 2004 Service Manual

HONDAMATIC
MODE SELECT SWITCH
INSPECTION
Turn the ignition switch OFF.
Disconnect the ECM 34P (Black) connector.
Check for continuity between the ECM connector
terminals in each switch position.
Continuity should exist between the color coded
wires as follows:
~
Bluej Black!
Green
Position
orange
green
ESP
0
If the continuity is abnormal, disconnect the mode
select switch 3P (Black) connector, and perform the
inspection at the 3P (Black) connector in the same
manner as the previous step .
• If the continuity at the ECM is abnormal and con-
tinuity at the 3P connector is normal, check for an
open or short circuit, or loose or poor connector
contact.
• If the both continuities are abnormal, replace the
mode select switch.
REPLACEMENT
Disconnect the mode select switch 3P (Black) con-
nector.
Always replace the
Remove the screws, throttle housing cover (mode
gasket wIth a new
select switch) and gasket.
~, .
24-40
3P (BLACK) CONNECTOR