Table of Contents
Advertisement
ALTERNATOR CHARGING COIL
INSPECTION
Remove the right tank side cover
(page
3-4),
Disconnect the alternator 5P (Natural) connector.
Check
the
connector for loose contacts or corroded
terminals.
Measure the
resistance
between the Yellow wire
terminals
of
the
alternator side connector.
STANDARD:
0.1
-
1.0
n
(at
20°C/
68°F)
Check for continuity between each Yellow wire ter-
minal of the alternator side connector and ground.
There should be no
continu
ity.
Replace the
alternator
stator
if
resistance is out of
specification, or if any wire has continuity to
ground.
Refer to page 11-10 for
alternator
stator replace-
ment.
REGULATOR/RECTIFIER
WIRE HARNESS INSPECTION
Remove the
resonator
chamber
(page
6-5).
Disconnect the regulator/rectifier 5P (While)
connec-
tor.
Check the
connector
for
loose contacts or corroded
terminals.
BAITERY/CHARGING SYSTEM
19-9
Advertisement
Table of Contents
Troubleshooting
