The blink codes for the 2006 Honda Rancher AT 400 are displayed on the gear position indicator as a series of blinks when retrieving problem codes. Each blink lasts approximately 1 second. To retrieve the codes:

1. Ensure the gear is in neutral and the neutral indicator is on.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON while pressing both the UP and DOWN ESP shift switches simultaneously.
4. Release the switches immediately, then press both again for 2 seconds or more.
5. The gear position indicator will blink to show the problem code.

If "N" stays on without blinking, repeat the procedure. If the indicator blinks indicating a system failure before showing a code and the code cannot be retrieved, troubleshoot Problem Code 3 or 7.

This answer is automatically generated