FRONT WHEEl/SUSPENSION/STEERING
Tighten the nut while holding the joint stud flats
with an open end wrench.
TORQUE:
54 N·m (5.5 kgf·m, 40
IbUt)
Install a new cotter pin.
Install a new dust seal into the hub with the metal
side facing out until it is flush with the hub
surface.
Apply molybdenum disulfide grease to the dust
seal.
Apply molybdenum disulfide grease to
the
drive
shaft
splines.
Install the brake drumlwheel
hub.
Install the
ax
le nut and tighten it to the specified
torque.
TORQUE:
78
N·m
!8.0 kgf·m, 58Ibf.ft)
Further
tighten
the hub nut until its grooves align
with the cotter pin hole.
Inst
all a new cotter pin
.
Install
the
wheel (page 14-12).
OUST SEAL
14-21