Honda Fourtrax Rancher AT 2004 Service Manual page 466

HONDAMATIC
6. Move the drive mode select swilch to AUTO.
7. Turn the ignition switch ON while pushing both
the UP and DOWN shift switches (ESP shift
switches) simultaneously (do not release the
shift switches yet).
Wait
8
moment and check that the "N" blinks at
the gear posilion indicator.
8. Immediately release both the UP and DOWN
shift switches, then push and release the shift
switches in the order of UP, DOWN, and UP (do
not hold onto the switch) .
• A constant "-" should be displayed on the gear
position indicator.
DRIVE MODE SWITCH
0:
If the flU!
posit/OIl
/f)(fiutOf
shows
the
cons/ant display of
'N '
Of
the cOllrro/
• Usten for the control motor operation sound (the DOWN
control motor should function at this time to L _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
-.l
motor
did
nor cycle,
adjust the angle sensor).
tum the iQnitlOll
smIdt OFF and 9.
'tJPUt
the proce-
dur. from slep 1
Within 5 seconds of the display of --" and while
I----::::::~---------_,
the control mOlor is operating, move the Ihrottle
lever from the fully closed position to the fully
opened position, and Ihen move
it
to the fully
24-10
closed position again .
""~~,0'~
,~,
,
' "
THAOITLE LEVER
,O.When the throule seuing is complete, the indica·
~================::;
lion on the gear position indicator changes from
the constant display of --" to the constant dis·
play of "N."
l '.Raise the vehicle off the ground and support it
with a Jack or work stand. Make sure all the
wheels are completely off the ground.
12.Aemove the rear wheels (page 14-12).
AWARNING
The rear wheel hubs are rotating at high speed
while setting the ESP ratio .
• Make sure the vehicle is always supported
securely .
• Be SUfe your hands, fingers and clothing are
out of the way from the rear wheet hub.
."/
,
,-
"
. . . . , .
,
GEAR POSITION INDICATOR
Revised: November 2004, 2004-2005 TRX400FAlFGA
C2OO4
American
Hondll Molor Co .• lroe . • AU
R/ohts
Reserved
MSV10892 (00f 1l )