Suspension Arm - Honda 2005-2008 RX500 FA Service Manual

'61HN252' by American Honda Motor Co. - Page 285 of 540
[2005-2008] [TRX500 FA/FGA]

SUSPENSION ARM

1 of 1
Install the brake disc and tighten the new disc plate
bolts to the specified torque.
TORQUE: 42 N·m (4.3 kgf·m, 31 lbf·ft)
INSTALLATION
Install the wheel hub, hub nut and tighten the nut to
the specified torque.
TORQUE: 59-78 N·m (6.0-8.0 kgf·m, 43-58 lbf·ft)
Install a new cotter pin.
Install the front brake caliper (page 16-14).
Install the front wheel (page 14-12).
REMOVAL
Remove the wheel hub (page 14-16).
Remove the brake disc guard bolts and brake disc
guard.
Remove the cotter pin.
Remove the tie-rod ball joint nut while holding the
joint stud flats with an open end wrench.
Remove the tie-rod from the knuckle.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
FRONT WHEEL/SUSPENSION/STEERING
BOLTS
HUB
COTTER PIN
BOLTS
TIE-ROD
COTTER PIN
BRAKE DISC
NUT
DISC GUARD
NUT
14-17
3/9/2008 11:04 PM