Honda Fourtrax Rancher AT 2004 Service Manual page 321

Coat the piston and cup with clean brake fluid .
Do
not allow the
Install the piston into the wheel cylinder.
pis ton cup lip to rum
inside out
Apply silicone grease to the boot grooves in the pis·
ton and cylinder body.
Install the piston boot onlO the cylinder and piston
grooves properly.
Apply silicone grease to the adjuster nut.
Apply silicone grease to the adjuster screw threads
and adjuster nut spindle outer surface.
Install the adjuster into the master cylinder.
Apply sealant to the cylinder's mounting locations
on the brake panel.
Install the cylinder assembly A and B, bolts, wash ·
ers and nuts.
Tighten the nuts and bolts to the specified torque.
TORQUE:
8
mm nut:
6 mm bott:
17 N'm (1 .7 kgf·m. 12 Ibf.ft )
8 N·m (0.8 kgf·m . 5.8 Ibf.ftl
Install the brake pipe as shown by tightening the
joint nuts to the specified torque.
TOROUE:17 N·m (1.7 kgf·m , 12 Ibf·ft)
BRAKE SYSTEM
ADJUSTER SCREW
I
PISTON
/
SPRING LOCK
I
CUP
~
~ BOOT
NUTNIASHER WHEEl CYLINDER B
.-.~-.
WHEEL CYLINDER A T
16-19