Honda Fourtrax Rancher AT 2004 Service Manual page 389

Apply molybdenum disulfide grease to a new hub
dust seal lip and install it into the left wheel hub
until it is fully seated.
Apply molybdenum disulfide grease to the left
spline of the axle and install the wheel hub.
Install the hub nut and tighten it t o the specified
torque.
TORQUE: 137 N'm (14.0 kgf·m , 101Ibf·ft)
Further tighten the hub nut until its grooves align
with the cotter pin ho le.
Install a new caner pin.
00
not get grease
Coat a new O· ring with grease and install it into the
on the brake
shoe brake panel groove.
limngs.
Install the brake panel assemble onto the axle.
Install new brake panel nuts and tighten them.
Install the following:
- brake cables (page 16·26)
- rear break drum (page 16-28)
- rear wheal (page 14-12)
Fill the gear case with the recommended oil (page 4-
15).
REAR DRIVING MECHANISM
COTTE'R PIN
WHEEL HUB
;;.;;.;;;..;;~; _
ASSEMBLY
18-23