Angle Sensor System - Honda Fourtrax Rancher AT 2004 Service Manual

13. Angle Sensor Input Voltage Insp ection
Turn the ignition switch ON.
Measure the voltage between the wire harness
side connector terminal (page 24-421.
Connection: White/ red 1+) - Gree n/ blue (-)
Is the voltage within
4.7 - 5.3
VI
NO - Faulty ECM - After replacement. per-
form initial setting procedure.
YES - GO TO STEP 14.
14. Angle Sensor Resistance Inspection 2
Remove t he angle sensor (page 24-431,
Check that the resistance at t he angle sensor ter-
minal varies while turning the sensor shaft (page
24-42r"
Connection : Yellow/ blue 1+1 - Green/ blue H
Standa rd: 0 to 1.6 - 2.4 kO (20 g C/60"F)
Is there norma' condition Bnd standard resis-
tance?
NO - faulty angle sensor - After replace-
ment, periorm initial setting procedure.
YES - Faulty ECM - After replacement. per-
form initial setting procedure.
PROBLEM CODE 6: ANGLE SENSOR
SYSTEM (AUTOMATIC TRANSMIS·
SION SWASH PLATE ANGLE)
1. Angle Sensor Connection Inspection
Check for loose or poor contact on the ECM 34P
(Black) connector.
I
HONDAMATIC
qLt!t-
W/R - - - - - ,
G/Bu
L - - _ - {
V )------'
{ ff1!J.-
GIS, - - - - ,
Y/Bu
L----{ Q f------'
24-25