Demounting; Demounting Cpu 01Xc - YASKAWA CPU 013C Manual

Basics and mounting
Demounting > Demounting CPU 01xC
Shield attachment

2.6 Demounting

2.6.1 Demounting CPU 01xC

Proceeding
Remove connector
28
1 Shield bus carrier
2 Shield bus (10mm x 3mm)
3 Shield clamp
4 Cable shield
To attach the shield the mounting of shield bus carriers are necessary. The shield bus
carrier (available as accessory) serves to carry the shield bus to connect cable shields.
1. Each System SLIO module has a carrier hole for the shield bus carrier. Push the
shield bus carrier, until they engage into the module. With a flat mounting rail for
adaptation to a flat mounting rail you may remove the spacer of the shield bus car-
rier.
2. Put your shield bus into the shield bus carrier.
3. Attach the cables with the accordingly stripped cable screen and fix it by the shield
clamp with the shield bus.
By means of a screwdriver there is the possibility to remove the connectors e.g. for
module exchange with a fix wiring. For this each connector has a release lever centrally
on its top side. Unlocking takes place by the following proceeding:
1. Power-off your system.
2. Remove connector:
Push your screwdriver horizontally into the slot between connector and release
lever, until it stops.
VIPA System SLIO
HB300 | CPU | 013-CCF0R00 | en | 16-40